مقالے کی معلومات
جلد
شمارہ
مقالے کی قسم
زبان
تلخیص
The casualties due to collapse of buildings are enormous either through blast or vehicle strike
which could have been reduced if the buildings have resisted progressive collapse after the accidental
removal of vital load bearing elements. In this research, progressive collapse (PC) potential of an
existing reinforced concrete (RC) building has been evaluated analytically using Nonlinear FEM
software following General Services Administration guidelines. Linear static, non-linear static, linear
dynamic and non-linear dynamic analyses have been carried out to explore PC potential. Building
under consideration was designed for Earthquake Zone-2B and has potential for PC in linear static
analysis while non-linear static and non-linear dynamic analysis results have shown that there is no
potential for PC. Results of analysis have been compared by taking deflection under joint where the
column is removed and is used as base for comparison. Results show that linear static procedure is
conservative as compared to non-linear analysis. Non-linear static and non-linear dynamic analysis
provides almost similar results. There is negligible effect of material strength and damping variations
on PC. In linear static analysis decrease in deflection of joint at column removal location is
approximately 7% for every 7MPa (1000psi) increase in fc’ while 9% reduction is observed in nonlinear dynamic analysis. Damping that can be achieved through installation of dampers has been
found beneficial up to 10% value. Increase in damping ratio beyond 10% of critical damping has
negligible effect on deflection and PC.
A. U. Qazi, A. Majid, A. Hameed, M. Ilyas. (2015) Non Linear Progressive Collapse Analysis of RC Frame Structure, Pakistan Journal of Engineering and Applied Sciences, VOLUME 16, Issue 1.
-
Views
2089 -
Downloads
153